BIOPTRON Light Therapy has to be performed individually.
The duration of each session and of the entire course
of treatment depends primarily on the health problem and
area to be treated. Depending on the indication, the BIOPTRON
Light Therapy treatment will only take a few minutes once
or twice a day (See BIOPTRON treatment guidelines). The therapy should be applied while you
have time to relax and can enjoy it.
Step 1
Before using the BIOPTRON Light Therapy, clean the area
that you wish to treat. Any dressings or coatings must be removed before
treatment.
Step 2
Relax and point the light beam onto the area to be treated.
Hold the device at a right angle of 90° and keep a
distance of approx. 10 cm (4 inches). The light beam should
not be moved during the treatment. Cover large areas by
treating them point-by-point until the whole surface has
been covered.
Step 3
Apply the BIOPTRON Light Therapy once or twice a day (e.g.
every morning and/ or evening) for in general 4 to 10
minutes or according to the instructions of your physician
or therapist.
Step 4
Repeat the above points for each area on the body to be
treated.
Step 5
Unplug the device after use.
HOW OFTEN SHOULD BIOPTRON BE USED ?
BIOPTRON Light Therapy is completely safe to use and is
without harmful side effects. It can be used both as a
complementary treatment to support conventional medical
methods, and as a mono-therapy for certain indications.
As A General Guideline The Following Treatment Frequency
Is Recommended :
For ACUTE Cases :
Apply twice a day
For CHRONIC Cases :
Apply daily or 3 to 4 times a week
For SEVERE Cases :
Apply every 6 to 8 hours
For General Health :
Apply 2 to 3 times a week
Note : Maintain a distance of 10cm (4”) from the lamp filter
to the treated skin area. BIOPTRON has no harmful side
effects. However, for serious medical conditions it is
always advisable to consult your physician first to establish
whether other medical or surgical interventions are also
required.
